This is a Rev 2.0 board, programmer says pin isn't correct.

As usual you rock!!!! I might check out what you use. Thank you again sir!

does anyone happen to know the pinouts for the EC, I don't see them in the SVOD4 database :(

Hey there, before I upload a BIOS to get fixed, is it possible to remove the forced overclocking garbage in it?

Additional Files if Needed

Hello, I need a factory BIOS built for a FA617NT which I have attached from Asus Website due to serious BIOS corruption replacing IC. ASUS TUF Gaming A16 Advantage Edition (2023) Motherboard FA617-PMV-VGT 6050A3460701-MB-A04 AMD Ryzen™ 7 7735HS AMD Radeon™ RX 7700S

I'm already loading Sonoma on it :) Thank you again

I didn't take a picture but it kept erroring out on the SSH connection failing, putting it ON 9.6 fixed the error

I had no choice to put it on 9.6 to begin with or the tool wasn't working lol

So install iBridge 9.6, then go through activation process and then restore 9.6 again sheesh LOL

o_O

SERIAL C02XK9TCJK7G

Paid ECID 1711669584199718

Paid ECID 1434502769868838 Thank you for the info. I will use the Update Blocker from now on

Paid ECID 6036156672409638

Paid for the service here is the ECID 1699167359664166

So it must mean that I have a bad chip(s). It fails every time on blank check and doesn't even show the type of ITE

Question, I have been trying to program the IT5507e on the zif128 for the above mentioned motherboard in this post and it keeps failing on blank check, it actually doesn't isn't other than an ITE series being recognized as the actual chip ID on the svod4. Is this only programmable while it's on...

Neither of those worked. I finally found the original dump as attached.

Hello, need a factory bios please. Ryzen 7 7000 Series Nvidia RTX 4060 Model N23Q4 AN17-41-R7G3 Serial NHQKMAA0013341A49F7600

The old bin showed the error I do believe 4010. I would have to force it into DFU mode as it was stuck in recovery. The bin you all made worked perfectly as soon as I connected to the other mac it went directly into DFU mode without forcing it and it looked like it was going to work this time...

AMrestore error Generic Error guess I'll just throw it in the parts bin

Got it, doing it now

There's no data in the image it's all FF

Built the socket yay! Here's the very corrupted dump and the serial in it is garbage

give me a bit, I need to take all the electronic components off the blown T201 and install pins to go into my programmer so I can use the socket

I don't have the EMC number as the board was bought without any information :( It was bought to replace a burnt out board

Hello, I have a 820-01987 that I need a SoC Rom image for. Whoever programmed it when I bought the board it was banned from activation and I just want to clear whatever junk was programmed in it with a fresh image. Just hoping someone out here may have access to it.